Possible injury or death.
Tommy lift installation instructions.
Use only tommy gate do not modify lift or its safety service parts installed by an warning read operator s manual before operating equipment.
Warning do not bend safety bar located on box cover of gate.
Refer to available option sheet for bumper installation.
Do not exceed the rated lift.
Refer to the installation instructions for more cutting details.
Slide styrofoam log under far end of section and float into position.
Needed call tommy gate use only tommy gate do not modify lift or its safety service parts installed by an warning read operator s manual before operating equipment.
Drill all holes for assembly pins.
Do not exceed the rated lift decal no.
8 located on the control shield.
While on shore install brackets posts and foot pads.
This manual applies to both 42 and 50 travel lifts.
Let pipe slide down to lake bottom then tighten bracket adjusting bolt.
Accident prevention and safety are dependent upon the awareness concern prudence and warning caution danger to the owner operator note.
Introduction page to the installer operator 3 safety decals and tuckunder description safety decal location and descriptions 4 5.
Tommy gate or an authorized distributor for assistance.
Remove winch and go to the next post leg.
How to operate a tommy lift on our box truck.
Gas lift bed frame installation guide.
Install all pins post bumpers optional and safety caps.
Tommy lift woodbine manufacturing co.
Installation of tommy docks in water first year only.
If an instruction or illustration.
Lift or lower dock to level then tighten dock bracket adjusting hex bolt.
Parts list 66 x bolt a 70 for king size 10 x bolt b 14 for king size 4 x corner connector 4 x corner legs 10 x nuts 14 for king size parts list continued 4 x bracket a 2 x bracket b 1 x bracket d 2 x support legs 4 for king size.
095266 page 1 of 32 rev 4 7 15 19 tommy gate the original hydraulic lift n.
Woodbine iowa 800.
Walk out to bracket locations loosen bracket adjusting bolt.